E-series AC Charger
Configuration manual V1.3
27
●3- RFID Setting
Fig.3-9: RFID Setting interface
The setting interface consists of two areas, BANK1 and BANK2. The BANK1 area
displays the card numbers of the three built-in RFID cards, and the card number
read only.
The BANK2 area is used to set and modify the built-in card number. The “Read”
button is used to read the card number. When the charger is in the standby state,
click the "Read" button to attach the written card to the RFID card reading area. At
this time, the "Read RFID" post will show the card number that has been read.
Click "Write Card 1", "Write Card 2" or "Write Card 3" below to write it to the RFID
card number position of BANK1.
After the modification of the overall card number is completed, click the "Confirm"
button of BANK1 in the "RFID card setting interface", and the system will output the
set RFID parameter information in the form of a report. After confirming that the
user is correct, press the "confirm" button again to complete the setup.
When adding a new RFID card, you first need to ensure that there is already a 16-
