6
LINCE ITALIA S.p.A.
2. INSTALLATION
To proceed with the correct installation of the transceiver on the wall, follow the instructions below:
•
unscrew the four closing screws of the cover;
•
open the pre-cuts of the cable passage according to your needs;
•
fasten the plastic wall base through the holes present and using suitable plugs, be careful also to fix the anti-tear plate in order
to guarantee its function;
•
power supply the board
•
if you decide to proceed with the basic programming, refer to the contents of the relative paragraph;
•
if you decide to proceed with the extended programming, refer to the contents of the relative paragraph;
•
make the appropriate electrical connections;
•
close the cover after programming
3. PROGRAMMING AND BASIC MANAGEMENT WITHOUT SOFTWARE
NOTE:
Both programming procedures must be carried out with the cover open so as to open the tamper, otherwise it is not possible
to modify or memorize new devices.
3.1 DEVICES STORAGE
•
This programming mode is useful for quickly storing radio devices without having the possibility to change their default detection
parameters and without changing the default settings of the outputs for which the use of the software is required. Then follow
the steps below:
•
Open the device tamper to proceed with programming;
•
press the multifunction button once and wait for the device monitoring status LED to start flashing;
•
long press the multifunction button until you hear a long sound produced by the transceiver;
•
entry into programming mode is indicated by the intermittence of the device tamper status LEDs and supervision status and the
first free position among the eight available (32 if there are slave boards connected);
•
store the device referring to what is reported in its manual;
•
confirmation of successful storage will be indicated by the issuing of a long sound by the transciever and the automatic exit from
the storage procedure;
•
pto memorize other devices repeat the procedure;
•
to exit the storage, press the multifunction button again.
3.3 DEVICES STATUS DISPLAY
During normal operation of the transceiver, various information is displayed on the LEDs as shown in the “devices status display”
table. To obtain more detailed information, it is possible to enter the different menus by pressing the Multifunction button for the
number of times shown in the detailed device status display table
3.2 DEVICES ERASURE
To selectively delete the stored devices, press the multifunction button until the sabotage signaling LED lights up. At this point, keep
the button pressed until the device status LEDs light up: only those relating to the positions occupied will light up; if any expansions
9589-GOLD-TXRX-S are connected, they will also light up on them in sequence. Again using the multifunction button, select the
device to be deleted by pressing the button until the corresponding LED flashes; keep the button pressed until the buzzer of the card
emits a short sound confirming the cancellation. To exit the erasure procedure, press the button until you get to the last stored device
(including the expansions) and the total shutdown of all the LEDs on the card.
Table 4 - Devices status display
LED
Description
Slow flashing
Fast flashing
Staeady ON
1 2 3 4
Device status LEDs
Sleeping device
Device alarm memory
Alarm
Devices supervision status signaling LED
n. a.
n. a.
At least one device
in monitoring alarm
Device status and fault LED
n. a.
n. a.
At least one device
with low battery
Device sabotage and masking signalling LED
n. a.
n. a.
At least one device
in sabotage or
masking
NOTE:
•
refer to the next section where the extended programming is illustrated to know in detail the parameters that are set by
default;
•
the alarm memories are automatically deleted after having carried out a complete visualization of all the three signaling
LEDs either by pressing the multifunction button for a long time or by changing the status of the OFF terminal.
