IS 318 ECN 3607
Page 7 of 12
Access to components requires removal of the hood. Remove the 2 screws on the
underside of the front of the hood (Fig 3 - A). This will release the 2 retaining clips,
which can be removed by pulling them into the cavity. Hinge back the hood to clear
the inner flue and slide 10mm to the right to enable it to be lifted clear. Replace
after servicing by reversing the procedure. Figure shows top raised for clarity
– will
not rise until clips are undone.
Fig 3
Element
Remove hood and disconnect cables to element.
Remove the 3 element mounting plate screws and remove the element from inside
grill by sliding out the mounting plate from the side.
Remove the defective element by unscrewing from the mounting plate.
Replace in reverse order.
Energy regulator
Remove hood. Remove knob from energy regulator.
