Lincar Siria 840, Using Instructions And Maintenance

Page: 61 / 120

IT-GB-FR
mod. 740-740 ECO-740/SA-740/SA ECO-740N/SA
61/120
REGULATION of the Room Temperature
The setting of the room temperature means to put a limit to the heating process of the
appliance, whenever the room temperature exceeds the selected value (i.e. 20°C) the
appliance reduces automatically the power commuting on minimum (power 1)
- Push on P2
- Regulate the temperature the buttons P1 and P2
- Terminate the regulation of the temperature of the water
pressing shortly on button P4, the modification will be memorized and
the display returns to the previous indication
STARTING CYCLE
1st Lighting (new appliance and whenever the pellet container has been completely emptied
-Put the fuel into the container and switch on the appliance
-In case the display is signalling an alarm keep the push button P4
pressed
-In case the display is signalling “Final cleaning” wait until on the
display appears “Off” (approx. 15 minutes)
- Appliance in switched off condition display “OFF”
- Push on P3 to get access to the programmation menu.
- Push P5 to go on MENU 06
- Push P3 to go to the menu load initial
- Push on P1 to activate the continuous charge of fuel.
- Once the pellet has started to fall into the
burner basket press on push button P4 to stop
the fall of fuel into the burner basket.
- Empty the burner basket from the fuel and put it again in its correct
place.
- Push P4 and keep it pressed for few seconds until the display reports
the start of the lighting
NORMAL STARTING CYCLE
Push P4 and keep it pressed for few seconds
The appliance begins an automatic cycle to effect the lighting, this cycle is composed by 3
phases, which are shown on the display :