Page 6 of 20
Repairs
In order to avoid the risk of malfunction, all TWINDRIVE
®
repairs must only be carried out by authorised
LINAK workshops or repairers, as special tools must be used and special gaskets must be fitted.
TWINDRIVE under warranty must also be returned to authorised LINAK workshops.
Warning!
If any of the TWINDRIVE
®
products are opened, there will be a risk of subsequent malfunction.
Furthermore the warranty will not cover, when the product has been opened by unautorised
personnel.
Warning!
The TWINDRIVE
®
systems do not withstand to cutting oil.
Warning!
If the supply cable is damaged the product must not be used or connected to the mains. The
product has to be replaced by a new to avoid a safety hazard.
Before installation, reinstallation, or troubleshooting:
• Stop the TD1
• Switch off the power supply and pull out the mains plug.
• Relieve the TD1 of any loads, which may be released during the work.
Before start-up:
• Make sure that the system has been installed as instructed in this User Manual.
• Make sure that the voltage is correct before the system is connected to the mains.
(See TD1 label on page 10).
• System connection. The individual parts must be connected before connection to the mains.
During operation
• Take care that the cables are not damaged.
• Unplug the mains cable on mobile equipment before it is moved.
• The products must only be used in an environment, which corresponds to their IP protection.
