Linak HOMELINE LA18 IC Standard Series, User Manual

Page: 7 / 26

Page 7 of 26
Before installation, re-installation, or troubleshooting:
• Stop the actuators
• Pull out the mains plug.
• Relieve the actuators of any loads, which may be released during the work.
Before start-up:
• Make sure that the system has been installed as instructed in this User Manual.
• Make sure that the voltage of the actuator system/SMPS is correct before the
system is connected to the mains.
• System connection. The individual parts must be connected before the actuator
system/SMPS is connected to the mains. See the User Manual for LINAK actuators,
if necessary.
During operation
• If the actuator system makes unusual noise or smells, switch off the mains voltage
immediately.
• Take care that the cables are not damaged.
• The products must only be used in an environment, that corresponds to their IP
protection.
Misc.
Updated manuals and declarations can always be found here:
www.linak.com/homeline