Page 21 of 36
Initialisation of the DESKLINE
®
parallel system
Downward direction
The DESKLINE system is initialised by pressing the down button once and holding it down until the lifting column runs into
end stop. Release the button and press down again within 10 seconds. The desk will run further in and then run approx. 5
mm out again. Do not release the down button until the movement has stopped completely.
If the button is released before the sequence is completed, the initialisation is interrupted and must be started again
from the beginning.
Upward direction
PIEZO columns (IID):
No initialisation in upward direction required.
Non-PIEZO columns (no IID):
The first two times the system moves into end stop in upward direction, the system will detect overload. Afterwards the
system will only run to approximately 2 mm before end stop.
Approx. 5 mm