Page 19 of 36
Installation of CBD6S (SMPS)
Do not pack the CBD6S in heat insulating material.
Place the CBD6S so it can emit heat through its surface to the surroundings.
Mounting the CBD6S
1. Plug the mains cable into the CBD6S.
2. Place the mains cable in the groove for cable relief.
3. If needed, place the other cables in the grooves to optimise the desk design and manage the system cables.
4. Mount the CBD6S using two screws with a head diameter of 10 mm (8 to 10 mm can be used).
5. Fasten the mounting screws (max. torque 1 Nm).
Notes:
• If the control box is mounted in a top frame bar with the width of the motor housing, it can be mounted with one screw only
• The surface to which the control box is mounted should have an evenness better than ±0.5 mm
• The control box can also be mounted using one or two M6 nuts and screw counterparts, see Dimensional drawings
• The mains plug must be accessible when the CBD6S is mounted so that the supply to the CBD6S can be disconnected
if replacement is required.
For mounting and operation of the desk panel, please see the separate user manual for desk panels.
