Assembly Instructions
0190045 Page 1 of 4
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts or
accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Rechargeable Battery Pack System
99045
(1) 0190042
Battery cable
(1) 0110254 - 2” x 3” Hook strip
(1) 0110255 - 2” x 3” Loop strip
(1) 0190041
BA001 Battery
(lithium-ion)
Installation
1. The battery and tray should be free from dirt, dust, grease and
moisture to maximize hook and loop adhesion. Remove the
adhesive backers and attach the hook and loop strips to the
bottom of the battery as shown.
Figure 1.1
.
2. Plug the battery cable into the battery.
Figure 1.2
.
3. Unplug the control box AC power plug and leave the power cord in
the bottom of the tray. This AC cord will be used later for charging.
4. Attach the battery to the bottom of the tray as shown.
5. Plug the battery cable into the control box.
Battery / Control Box Compatibility:
Battery
Cable
Battery
Control
Box
Figure 1.2
Figure 1.1
Battery
Loop strip
Hook strip
(Freedom One eLift shown)
Tray
Battery cable
Older CBD4 Linak control
boxes are not compatible
with this battery pack.
The CBD6S Linak control
box is compatible with
this battery pack.
Shroud panel
Note:
On Freedom One eLift Lecterns, the shroud
panel can be removed with 2 screws and / or the
worksurface extended to access internal wiring.