Lin Engineering
Page 15
5/16/2016
Silverpak 17C-CE User Manual
Rev 1.11
Changing the Address of the Controller
Use a small Philips screwdriver to turn the dial so the arrow points to the desired
Address. Use this number when programming commands. For example, /
1
P1000R
Figure 8: Address Dial
Connecting Accessories
If you have purchased the Designer’s Kit, there is a Red Push Button and an Optical
Sensor included. Follow the schematics below in order to properly assemble
accessory pieces.
Push Button
Figure 9: Push Button Schematic
It is best to solder the Push Button to Pin 5 which corresponds to Input 4, then
solder Pin 6 (Power Ground) to the other side of the push button.
Input 1 Pin 2 (Black)
Input 2 Pin 8 (Blue)
Input 3 Pin 7 (White)
Input 4 Pin 5 (Orange)
Table 7
