CAUTION
CAUTION
PLEASE USE
5/16" OR M8
EXPANSION BOLT.
請搭配使用
或
膨脹螺栓。
5/16" M8
Step 1
Remove
the
bracket
from
the
base
Loosen the four bolts from the base (FIG.1) and push the hinge upwards to separate it from the base (FIG.2).
Step 2 Secure the bracket base to the wall
Attach the installation sticker to the wall and drill four holes according to the instructions (FIG.3). Tighten
four bolts to secure the base to the wall (FIG. 4). To use the central hole on the base, first hammer the lid off
(FIG.5).
Note The bolts are not included in the package.
Step 3 Attach the quick release adaptor to the bracket
First remove the quick release adaptor from the camera body. Align the adaptor with the bracket before
tightening the bracket bolts (FIG. 6 & FIG.7). Then slide the adaptor and bracket together down the hinge to
connect to the base (FIG.8). Note: The three bolts on the adaptor must be loosened first to remove the adaptor.
60mm
Step 4 Slip the control wires through the bracket
Properly secure the safety strap to the bracket, and slip the safety strap, RJ-45 cable, and AC24V power
connector through the bracket (FIG.9 & FIG.10). Secure the bracket to the base (FIG.11)
Note: The AC24V power connector is not needed to be connected when a PoE device is used.
[
FIG.1]
[
FIG.2]
[
FIG.3]
[
FIG.4]
[
FIG.5]
60mm
CAUTION
CAUTION
PLEASE USE
5/16" OR M8
EXPANSION BOLT.
請搭配使用
或
膨脹螺栓。
5/16" M8
[
FIG.8]
[
FIG.7]
[
FIG.6]
