Liko Golvo 8000 Classic, Service Manual

Page: 20 / 26

Service Manual Golvo™ 8000/8008
Mobile Lift
• 3EN400404 Rev. 6 20 www.liko.com
l
www.hill-rom.com
6.2 Service, Control Unit CBL - Reset Service Interval Parameters
INPACT ON PARAMETERS
Changes of parameters when LSS, LDS or Manuel Service reset has been used:
Parameter: 1. LSS: 2. LDS: 3. Manual Service: Check Points in PM ***
Service Light * Unlit Unlit Unlit
TAAxT unchanged unchanged unchanged x ***
TAAxTR unchanged unchanged unchanged
PAAxT ** 0 0 0 x ***
PAKT ** 0 0 0
TADT unchanged unchanged unchanged
AAS unchanged unchanged unchanged x ***
ASERV +1 +1 unchanged x ***
IMED unchanged unchanged unchanged x ***
ALA unchanged unchanged unchanged x ***
AALA unchanged unchanged unchanged x ***
AOLA unchanged unchanged unchanged x ***
AABT unchanged unchanged unchanged x ***
AEUP unchanged unchanged unchanged x ***
AFSERV 0 0 +1 x ***
AEDWN unchanged unchanged unchanged x ***
SFSTAT N/A N/A N/A
IDNR unchanged unchanged unchanged x ***
AOLUP unchanged unchanged unchanged x ***
PADT ** 0 0 0 x ***
IMED20 unchanged unchanged unchanged
ELT unchanged unchanged unchanged
ELTCNT unchanged unchanged unchanged
CLIM1 unchanged unchanged unchanged
CLCT unchanged unchanged unchanged
CLIM2 unchanged unchanged unchanged
SINTT unchanged unchanged unchanged
SINTAS unchanged unchanged unchanged
CYCLET unchanged unchanged unchanged
PAOLUP ** 0 0 0 x ***
* Indicates Service Periodic Inspection interval reached.
** Service Interval Parameters (the PAAxT, PAKT, PADT and PAOLUP are all used to determine Service intervals)
*** Parameters to use in the Preventative Maintenance
CBL RESET SERVICE INTERVAL PARAMETERS
After the Periodic Inspection has been performed Service Light and Service Interval Parameters* in the Liko Diagnostic
System™ has to be reset. Reset can be done using one of the following Service Tools/Methods:
Prod. No.
21090024
1. Liko™ Service System, LSS
( Requires a computer)
Read and store the data from the Control Unit CBL into a computer. Data can also be
transfered to a Liko™ Server. Can also reset the ELT-light (Expected Life Time).
Use when Periodic Inspection or Preventative maintenance is performed.
Service Documents for the lift can be printed. Use for tracking and and transfer data
when Spare Parts are changed.
Prod. No.
21090016
2. LDS Service (LDS)
Reads the data from the Control Unit CBL. Use when Periodic Inspection or Preventative
maintenance is performed.
- 3. Manual Service
Resets the Service Interval Parameters*.
Service Interval Parameters should only be reset after a complete Periodic Inspection
Use the following combination of buttons on the control panel:
A: Press and hold button 1 & 2
B: While holding 1 & 2, press button 3, and hold all three
buttons for three seconds.
Works from Item No: CBL20001-05, see
label on CBL
1
2
3