SFA-5000 • SFA-10000 Profibus
noise. The connection point to ground can be situated both on the device
side and on user’s side. The best solution to minimize the interference
must be carried out by the user. Provide the ground connection as close
as possible to the encoder. We suggest using the ground point provided
in the cap, use one TCEI M3 x 6 cylindrical head screw with two tooth
lock washers.
1.3 Mechanical safety
•
Install the device following strictly the information in the “Mechanical
installation” section;
•
mechanical installation has to be carried out with stationary mechanical
parts;
•
do not disassemble the unit;
•
do not tool the unit;
•
delicate electronic equipment: handle with care; do not subject the device
to knocks or shocks;
•
respect the environmental characteristics of the product;
•
we suggest installing the unit providing protection means against waste,
especially swarf as turnings, chips, or filings; should this not be possible,
please make sure that adequate cleaning measures are in place in order to
prevent the wire from jamming;
•
to avoid failures, never exceed the maximum measuring length and
prevent the wire from tangling up;
•
never release the wire freely, always help the wire wind properly: risk of
personal injury and/or equipment damage;
•
always keep the wire aligned not to damage the equipment;
•
the stroke per turn of the draw-wire unit is 200 mm (7.874”).
MAN SFA_5000_10000_PB E 1.0
Safety summary
18 of 72