Lightwave Research EC-1, User Manual

Page: 79 / 112

EC-1 User Manual Problems and Solutions 6-3
6
OVER
Value
counter is
out of range Lamp strikes, lamp hours, or
fixture hours have exceeded
9999.
Reset the menu item that has
rolled out of range (see “Resetting
Lamp Hours (L/RS)” on page 4-5,
or “Resetting Fixture Hours (F/
RS)” on page 4-6).
OVER
TEMP Fixture is
overheated The fixture’s internal
temperature is too high.
• Move the fixture if it is too close
to a heat source.
• Remove any object which may
be obstructing the fixture’s
heatsink.
• Check and reduce ambient
temperature by turning on fans,
etc.
PRGM
TIME
Program
time has
expired
during an
upload
Bad board
Contact High End Systems
Customer Service (see “Getting
Help” on page Intro-3).
SVCC
ERR Sensor
power error
Bad board loose cable
Contact High End Systems
Customer Service (see “Getting
Help” on page Intro-3).
SEN1
ERR
Sensor
error for
color wheel,
cyan color
mixing
wheel, or
effects
wheel 1
Problem with the tab, sensor or
motor on the color wheel, cyan
color mixing wheel, or effects
wheel 1.
• Run a self-test on sensor 1
(see “Performing Self Tests
(SELF)” on page 4-11).
• Contact High End Systems
Customer Service (see
“Getting Help” on page Intro-3).
SEN2
ERR
Sensor
error for
magenta or
yellow color
mixing
wheel, or
effects
wheel 2
Problem with the tab, sensor, or
motor on the magenta color
mixing wheel, yellow color
mixing wheel, or effects wheel 2.
• Run a self-test on sensor 2
(see “Performing Self Tests
(SELF)” on page 4-11).
• Contact High End Systems
Customer Service (see
“Getting Help” on page Intro-3).
U.P.L.D.
Fixture held
in boot
mode
The fixture was disconnected
during an upload. Reconnect the fixture and perform
the upload again.
7DEOH 9041 $OSKD 0 1XPHULF 'LVSOD\ (UURU 0HVVDJHV
Display
Message
Problem Explanation Solution