Page 9 of 18
TL - 2448 LIGHTING CONTROLLER
Version 0.6
OWNERS MANUAL
12/27/2007
www.lightronics.com
Lightronics Inc.
509 Central Drive Virginia Beach, VA 23454
757 486 3588
CHASE RECORDING
Chase steps consist of scenes which have been previously recorded. When you record a chase step you are
telling the TL-2448 to recall a specific scene from a specific bank.
A chase must be active before it can be programmed from the chaser menu. You can do this from the normal
STATUS DISPLAY
. Enter the chase number on the keypad and push
.
If you want to program one of the
first 12 chase patterns, you can also make it active by pushing the
CHASE SELECT
button. The LED
indicators under the submaster faders will flash. Push a submaster momentary button to activate any one of the
12 chase patterns. Note that in either case, the lower left of the display shows the currently active chase and step
number.
Chase pattern recording is done from the
CHASER
menu which is accessed from the main menu after you have
made the chase active. You can also look at and change the existing chaser assignments from this menu.
The upper display row shows the current chase step number, the conventional bank-scene number assigned to
the step, and the moving light bank-scene number assigned to the step. The lower left of the display shows the
current chase number. The current chase number cannot be changed from this menu.
The bottom right of the
CHASER
menu indicates how the
Í
and
Î
buttons on the keypad may be used inside
the
CHASER
menu. When “NextItem” is visible, the
Í
and
Î
buttons will move you to the next or previous
menu item. You may change this action by pushing the
MENU
button. If you do this the display will show
“
Í
Alter
Î
” and you can use the
Í
and
Î
buttons to alter the value (up or down) of the currently flashing menu
item. For instance – when the step number is flashing and “
Í
Alter
Î
” is displayed you can look at the next or
previous step assignments by pushing
Í
or
Î
.
ASSIGNING SCENES TO CHASE STEPS:
The steps below are used if the menu shows “NextItem” in the lower left display corner.
1. Push
Í
or
Î
until the step number flashes. Enter the step number on the keypad and push
#
.
2. Push
Î
to advance to the conventional scene bank number. Enter the bank number and push
#
.
3. Push
Î
to advance to the conventional scene number. Enter the scene number and push
#
.
If you want to include a moving light scene in the chase step:
4. Push
Î
to advance to the moving light scene bank number. Enter the bank number and push
#
.
5. Push
Î
to advance to the moving light scene number. Enter the scene number and push
#
.
To end the chase recording process push
Í
or
Î
(while”NextItem” is visible) until a flashing “EXIT” appears in
the display lower right corner. Then push
MENU.
ST01 CS01-01 MS01-01
Chase-01 NextItem
CHASER MENU
