Page
2
of
6
FXLD136RGB LED FIXTURE
Version 0.1
OWNERS MANUAL
12/29/2010
www.lightronic.com
Lightronics
Inc.
509
Central
Drive
Virginia
Beach,
Va
234354
757
486
3588
DMX TERMINATION
A DMX chain should be terminated at the last
receiving device on the chain. This is done by
installing a commonly available 1/4 Watt, 120 Ohm
resistor across the DATA - and DATA + wires at the
last device. If you have only a few fixtures very close
together and a very short run to the controller then you
may be able to operate without the terminator.
OPERATION
Operating options are set using the LED display and 4
buttons
(MENU, ENTER, UP, DOWN)
on the rear of
the fixture.
Push
MENU
to access the operating options. Then use
UP
and
DOWN
to scroll through the available choices.
When you reach the option you want to set or change -
push
ENTER
.
Now you can view the current setting
for the option and or change it. Push
ENTER
to save
your changes. Push
MENU
to return to the current
option display. See the "MENU NAVIGATION"
diagram for additional details.
There are 5 main operation modes: DMX, Manual,
Auto, Sound, Master/Slave
DMX OPERATION
Use the
ADDR
menu to set the starting address of the
unit. You can set the starting address of the unit with
the
UP
and
DOWN
buttons.
The fixture uses three channels with allocations as
follows:
CHANNEL 1: 0 - 255 Red level (255 = maximum)
CHANNEL 2: 0 - 255 Green level (255 = maximum)
CHANNEL 3: 0 - 255 Blue level (255 = maximum)
MANUAL OPERATION
For manual operation the level red, green, and blue
LEDs may be independently controlled. Use the
rL-
-
,
gL--,
and
bL--
, menus to set the levels. The range is
from 00 (OFF) to 12 (Full On).
AUTO OPERATION
Auto operation includes 3 sub modes: Flash (strobe),
Auto Fade, and Auto Sequence.
AUTO FLASH
The Auto Flash mode flashes the current color. Use
the
FLAS
menu to set the flash speed and activate the
option. The range is from 00 to 12. 12 is fastest.
AUTO FADE
The Auto Fade mode cycles smoothly through a
sequence of seven colors. Use the
FADE
menu to set
the speed and activate the option. The range is from 00
to 12. 12 is fastest.
AUTO SEQUENCE
The AUTO SEQUENCE mode switches through a
sequence of seven colors. Use the
ASC-
menu to set
the sequence speed and activate the option. The range
is from 00 to 12. 12 is fastest.
SOUND OPERATION
Sound operation has a Color and a Flash submode.
Use the
SOUA
menu to invoke the Sound Color
option. The unit will sequence through a series of
colors in sync with music base notes.
Use the
SOUF
menu to invoke the Sound Flash
option. The unit unit will flash through a series of
colors in sync with music base notes.
MASTER/SLAVE OPERATION
Connect the units together using DMX cables. Set all
FXLD136RGB REAR VIEW
