25
1. Remove the outer sheath for a length of 15cm from the lower end
of the HVSC by cutting radially around HVSC cable with the supplied
insulation friction cutting tool. (This is less likely to damage
individual copper conductors than by cutting radially with a knife).
The lengthwise cut can be completed with a knife.
2. Remove the binder tape (2
nd
layer) for a length of 15cm from the end
of the HVSC, this will expose the outer screen copper conductors as
shown in Figure 16.
3. Fold outer screen conductors back without damaging them. For a
length of 5cm from the end of the HVSC remove XLPE insulation (4
th
layer) and inner binding tape (5
th
layer) to expose inner screen
copper conductors. Be sure not to remove outer screen conductors
in this step. It is recommended to use the insulation friction cutting
tool in this step.
4. Fold inner screen conductors back without damaging them. For a
length of 5cm from the end of the HVSC remove the inner PVC
spacer under the inner screen copper conductor leaving the inner
screen copper conductor in place.
Figure 15.
Figure 16.
Figure 17.
Summary of Contents for Stormaster ESE
