17
Initial LED Display
Second LED Display
Sub-mode
NStS
SrUn
Sound Activated
4- Slave Mode
Up-to 32 units can be daisy chained together with one single unit acting as Master and all other linked units
as Slaves. Slave units will all run in synch with the master unit without the need for an additional controller.
Connections can be made using standard DMX control cables with Master unit running in Auto Run or
Sound Activated Modes an placed at the start of the chain
Choosing Slave Mode
To select, use the “MODE/ESC” button and choose “SLAu”. When the “ENTER” button is pressed the LED
display changes to “Son” and the unit will be slaved to control signals coming from a Master unit
5- Service Modes
After major configuration changes it may be necessary to reboot or reset the unit.
Resetting the Unit
To select, use the “MODE/ESC” button and choose “rEST”(restore). Press “ENTER” to confirm. The unit
powers itself down and then on again for a few seconds. During this time the LED display will scroll “rEST”
from left to right, after which normal operation recommences.
Restoring factory defaults
To select, use the “MODE/ESC” button and choose “LoAD”(load). Press “ENTER” to confirm. The LED
display will change to “d001” to confirm a factory reset has been completed
Powering the unit initially
During the warm up the unit will auto test itself for a few seconds. During this time the led display will scroll
“rEST” from left to right .The unit then commences operation normally
6- DMX Modes
The unit supports 8 and 13 channel DMX Sub-modes from a standard desk. When a suitable DMX
connection is made, the “decimal point” in “d.001” will flash.
Setting DMX Addresses
Use the “MODE/ESC” button to display “d001”, “UP” and “DOWN” buttons allows individual DMX
addresses to be set from “d001” to “d512”
Choosing between DMX Sub-modes
The LED display shows the chosen control mode when the “MODE” button is pressed. Use “UP” and
“DOWN” buttons to choose the appropriated DMX control Mode
