14
To link fixtures together you must obtain data cables. If you choose to create your own cable
please use data-grade cables that can carry a high quality signal and are less prone to
electromagnetic interference.
3.3 3-Pin to 5-Pin conversion cha rt
Note! If you use a controller with a 5 pin DMX output connector you will need to use a 5pin to
3 pin converter.
The chart below details a proper cable conversion:
3.4 Setting up a DMX serial data link
3.5 Master/Slave fixture l inking
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3pin
connector of the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector.
Then, proceed to connect from the output as stated above to the input of the following fixture
and so on.
3.6 Orientation
This fixture may be mounted in any position provided there is adequate room for ventilation.
