6
If extension cords are used, make sure that the core diameter is sufficient for the required power consumption of the
device. All warnings concerning the power cords are also valid for possible extension cords.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the power-cord by
the plug. Never pull out the plug by tugging the power-cord. Otherwise, the cable or plug can be damaged leading to
mortal electrical shock. If the power plug or the power switch is not accessible, the device must be disconnected via
the mains.
If the power plug or the device is dusty, the device must be taken out of operation, disconnected and then be cleaned
with a dry cloth. Dust can reduce the insulation which may lead to mortal electrical shock. More severe dirt in and at
the device should only be removed by a specialist.
There must never enter any liquid into power outlets, extension cords or any holes in the housing of the device. If you
suppose that also a minimal amount of liquid may have entered the device, it must immediately be disconnected. This
is also valid, if the device was exposed to high humidity. Also if the device is still running, the device must be checked
by a specialist if the liquid has reduced any insulation. Reduced insulation can cause mortal electrical shock.
There must never be any objects entering into the device. This is especially valid for metal parts. If any metal parts like
staples or coarse metal chips enter into the device, the device must be taken out of operation and disconnected
immediately. Malfunction or short-circuits caused by metal parts may cause mortal injuries.
During the initial start-up some smoke or smell may arise. This is a normal process and does not necessarily mean
that the device is defective.
Caution:
During the operation, the housing becomes very hot.
Do not switch the device on and off in short inte
rvals as this would reduce the lamp’s life.
HEALTH HAZARD!
Never look directly into the light source, as sensitive persons may suffer an
epileptic shock (especially meant for epileptics)!
Keep away children and amateurs! Never leave this device running unattended.
OPERATING DETERMINATIONS
This device is a lighting effect for creating decorative effects. This product is only allowed to be operated with an
alternating voltage of 230 V, 50 Hz and was designed for indoor use only.
This device is designed for professional use, e.g. on stages, in discotheques, theatres etc.
Lighting effects are not designed for permanent operation. Consistent operation breaks will ensure that the device will
serve you for a long time without defects.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat, moisture or
dust. There should not be any cables lying around. You endanger your own and the safety of others!
This device must never be operated or stockpiled in surroundings where splash water, rain, moisture or fog may harm
the device. Moisture or very high humidity can reduce the insulation and lead to mortal electrical shocks. When using
smoke machines, make sure that the device is never exposed to the direct smoke jet and is installed in a distance of
0.5 meters between smoke machine and device. The room must only be saturated with an amount of smoke that the
visibility will always be more than 10 meters.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation (particularly in
cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
