5
.
Faulty Issue 5: the fixture is out of control
Troubleshooting:
◎
Make sure the DMX IP address is correct.
◎
Open base cover, check if the cables between DMX connector-- the X/Y board-- the Display
board are in good connection
.
◎
Check if signal cable have broken circuit and short circuit, if the display board keep flashing
means the signal connection is abnormal .
◎
Check if console setup is correct and ensure the console output signal is working
.
◎
Check if the communication chip on display board is burned, if yes, please replace a new display
board
.
The light fixtures start to be out of control or disorder after several hours working: the main reason
◎
is the PCB boards are in bad heat radiation, which means too hot. then, Open the base box cover,
clean the fan dust, make sure the fans are normal working, then clean up the air inlet and outlet.
Abnormal operation, which means the user adopts “ ONE ORDER, Multi-pcs fixture ON” working
◎
way. it generate Ten Thousand V Power to ignitor the lighting fixture in one second, which cause
the fixture out of control , PCB board burned etc. so, the factory recommend “ ONE ORDER ,
ONE FIXTURE ON”
3
.
Faulty issue 3: The spot is off-center, dark, uneven:
Troubleshooting:
◎
Check if the lamp come to the end of service life which cause the brightness insufficient,replace
the
same
model
lamp
.
◎
Check if there is dust on the optical components, clean it.
◎
Check if the power is under-supply.
◎
When the spot is off-center in left & right direction, finely adjust the lamp screw to change the lamp
position until the ideal spot.
◎
When the spot is off-center in up & down direction, please refer the 'User Manual' and adjust it via
display board menu, the following is the steps: Menu— SERVICE— Calibration— STAT Gobo— Gobo,
then adjust the spot. the password is 2222.
4
.
Faulty Issue 4: Reset failure, display board failure
Troubleshooting:
◎
Make sure the lighting fixture connect normally with the city power.
◎
Open base cover, check if the fixture’s power supply input fuse is burned.
◎
Check if the fixture’s power supply input and output voltage is normal
.
◎
Check the fixture’s interior connection cables and plugs to see if they are in good conditions.
◎
Check if the display screen is damaged, replace a new display board .
5
