LIGHT PROGRESS
STICK-NX [eng]
gen-2021
Pag. 9/16
MAINTENANCE
UV LAMP
Lamp maintenance is very important because UV-C light emitted by
the source is not visible to the eye, so, although you see the lamp
ON, its germicidal effect may not be sufficient to performs disinfec-
tion treatment.
Before reaching the lamp,
ALWAYS
switch off power supply
If UV-C lamp gets dirty (or gets dusty) clean it with a clean cloth and al-
cohol, and avoid touching the glass part with hands. To check UVC lamp
life number of hours, correct product code of the spare UV lamp please
refer to table 1. The lamp, once reached the timing for replacement,
must be replaced
, this operation is carried out as follows:
• Loosen the ring nuts on the lamp housing and let them slide
along the lamp; grab the lamp at the 2 ends and pull it in a direc-
tion parallel to the lamp.
• Repeat the steps in reverse to insert the new lamp.
TROUBLESHOOTING
UV LAMP
See MAINTENANCE.
BALLAST
All UV-STICK models are supplied with electronic ballasts
which guarantees an emission of 15% more if compared
with traditional ballasts. Furthermore, lamps are not influ-
enced by environment temperature that can goes until -
20°C. Finally, the switching on is immediate, with no
starter, and for this reason lamps last longer.
To preserve the original features of original IP protection
and isolation class, and to maintain all the characteristics
that guarantee a long-lasting life of this product, the bal-
last replacement must be done by qualified technicians
verified by Light Progress. In case of necessity, please,
send the device back to our facility for any kind of repairs.
If this is not possible you can order the entire supply
channel for replacement (for code, see Table 1).
USE
PROTECTIVE
GLOVES
WEAR
PROTECTIVE
GLASSES
