LIGHT PROGRESS
FLOW-C-NX [Eng.]
Rev. 2 Oct -2020
Pag. 10/16
► UV-FLOW-EL
Model
-EL
Gives you the possibility of remote-control functionality of the UV lamp.
Connected to the device there is a cable with 6 poles: a couple of poles carrying output signal to turn on LED indicating
the UV lamp (when on); another couple of poles triggers a voltage-free contact to be activated when a lamp stops
working (alarm function: open contact if at least one lamp UV is not working); in addition, there are two input wires to
power the device (phase and neutral).
The faulty lamp alarm contact can be powered by max. 500mA of current and 24V of tension, and can be connected to
an electronic panel as the "MASTER-ST” control
unit.
For the -EL models refer to the numbering of the wires on the table below.
Model
-EL
In the device
UV-FLOW-EL …
Multi-pole plug
and socket
Wire
Meaning
Black
wire for LED
terminal n°
1
Wire
n°1
1-
anode LED
for synoptic
2-
cathode LED
MASTER-ST......
Red
wire for LED
terminal n°
2
Wire
n°2
Power line 230V-50Hz - phase
terminal n°
3
Wire
n°3
3-
Line 230V-50Hz (Phase)
Power line 230V-50Hz - Neutral
terminal n°
4
Wire
n°4
4-
Line 230V-50Hz (Neutral)
Electrical ground
terminal
Y/G
Wire
Y/G
Y/G-
Ground terminal
Alarm board faulty lamp
terminal n°
5
Wire
n°5
5-6-
open contact = faulty lamp
(free contact without tension, max 500 mA-24V)
terminal n°
6
Wire
n°6
