Disassemble pieces as per below
9.)
Take a
White 30cm Bit Light
and thread the connector side of the
cable through the front hole of the grey brick. Thread it down and out
the bottom of the brick and then pull the cable all the way down until
the Bit Light is sitting at against the edge of the hole. Secure the Bit
Light in place by reconnecting the two trans clear pieces over the top.
Summary of Contents for LEGO Star Wars Slave 1 75060 Lighting Kit
