Light & Motion Stella 180-L LED, Owner'S Manual

Page: 21 / 36

21
Mounting the Light Head to the Cabeza Mount
*
1. Remove the Phillips head screw from the bottom of the
handlebar mount.
2. Remove both the small and large break-away disc.
3. The optional Cabeza mount comes fully assembled. Remove
the Phillips head screw from the Cabeza mount.
4. Align the track on the disk with the cut out on the light head.
5. Insert the Phillips head screw back through the hole in
the bottom of the base plate and tighten with screw driver.
Mounting Cabeza Light Head
The Cabeza mount is designed to be mounted on any standard,
vented bicycle helmet. Position the base of the light head on top of
the helmet, in the middle and slightly forward of center. Slide the
hook and loop strap down through the proper vent, back up through
the opposing vent and through the slot in the base of the light head.
Pull the strap tight and slide it back down the vent and affix it to the
“loop” side of the strap (inside the helmet). Plug the light head cable
into the top of the battery by aligning the arrow on the cable with
*Not designed for use with the Vega LED light.