18
(Fig. 24)
(Fig. 25)
(Fig. 26)
(Fig. 27)
Replacing Handle Batteries
The battery life of your Smart Grip Handles will vary depending on usage and
technique. But eventually the handle batteries will exhaust.
Replacing the handle batteries is an easy procedure. However, pay special attention
to the wear of the O-ring and to the orientation of the batteries.
1)
Using an allen key, remove the two screws on the back of the handle.
(Refer fig. 24)
2)
Remove the Handle Cap from the handle assembly. (Refer fig. 25)
3)
Remove old batteries from handle board.
4)
Install new 1/3 N batteries into the handle board. (Refer. fig. 26)
The +/- position of the batteries is critical. If batteries are
installed backwards, they will damage the handle board.
5)
Inspect the Handle Cap O-ring or replace with a new O-ring.
6)
Press the Handle Cap into the handle assembly so O-ring seals evenly.
7)
Replace both screws in Handle Cap and tighten using allen key.
Smart Grip O-ring and Battery Kit (part # 802-0117) (Refer fig. 27)
Kit contains one O-ring and battery set for one Smart Grip.