12
Bluefin Monitor - Bulkhead Installation
1)
Remove the rear plate.
2)
Using a flat head screwdriver or coin, remove the port plug. (Refer Fig. 16)
3)
On the inside of the rear plate, remove the protective bulkhead cover by removing
the four screws using a 5/64 allen key. (Refer Fig. 17)
4)
Feed bulk head cable through a bulk head port.
5)
Insert Bulk Head into rear plate until it is firmly seated.
6)
Tighten bulk head by turning the bulk head itself with a 3/4” wrench.
Do not plug in connector until the bulkhead is screwed in place.
7)
Attach bulk head cable into the primary bulk head connector on the inside of the
rear plate circuit board.
8)
Move the bulk head power switch to the on position.
9)
Replace the protective bulk head cover and tighten the four screws.
(Fig. 16)
(Fig. 17)
Attaching the Remote or Compact Monitor
1.
Attach clamp assembly to back of monitor.
2.
Attach monitor/clamp assembly to quick connect post by pressing down and
rotating until black sleeve locks into position.
3.
Adjust monitor by releasing clamp assembly (clockwise to tighten, counter
clockwise to loosen).
4.
Cable plugs are identical at each end. Attach by aligning the pins and pressing into
the bulkhead until the black rubber seats.Turn locking sleeve clockwise to tighten.
Port Plugs