Light & Motion Bluefin SR11, Owner'S Manual, Page: 20 / 28

18
Pre-Dive Checklist
1. Make sure you have four completely charged batteries in the monitor back.
2. Make sure you have a completely charged battery in the camera.
3. Verify operation of all housing controls.
4. Check that the lens lock is securely engaged and that the latch pin is in the locked
position. Clean lens if necessary.
5. Check that the monitor back O-rings are seated correctly and that the rear latches
are in the closed and locked position.
First Time Use
All Light & Motion equipment is pressure tested prior to shipping. However, there could be
unseen damage due to shipping. A test dive without the camcorder in the housing is highly
recommended. After the initial dive with just the housing, make the following checks:
1. Dry off housing exterior.
2. Remove the monitor back and visually inspect for moisture.
3. Reach inside the housing and trace a finger around all view ports and mating surfaces.
4. If any water is detected, contact the housing reseller or the Light & Motion service
department.
After Diving Care
1. Immediately submerge the housing in fresh water. While in fresh water, work all the
switches and press all the buttons to work any remaining salt water out of recessed
areas.
2. Remove housing from the rinse tank and towel dry.
Housing Storage
Store housing and Travel Case in a dry location the first 24 hours after a dive. Leave the
Monitor back off the housing to allow for air circulation. Similarly, leave Travel Case Lid about
two inches open. Allow any residual water to evaporate from the Travel Case prior to storing
the housing.