Light & Motion Bluefin SR11, Owner'S Manual, Page: 16 / 28

14
Bluefin Light Systems - Getting Started
Pictured on the facing page you’ll find the components of the Sunray 2000, Sunray 1000 and
Sunray lighting system. Take a moment to familiarize yourself with each part for identification
and use.
Revert to original button configuration
Perform the same swap procedure. Press either “Far” and “Near” or “Tele” and “Wide”
simultaneously and hold for three seconds.
Eventually the batteries in the Smart Grips will totally exhaust. Contact your Light & Motion
dealer to order a replacement battery and O-ring kit (part #802-0117), or remove the Smart
Grip handle cover and replace the two batteries located inside. Batteries are CR 1/3 N and can
usually be purchased from any store that stocks camera and watch batteries.
Charging Batteries
It is recommended that you charge your batteries when they are received. It is also
recommended to charge batteries once per month and again just prior to use.
1. The charger can accept an electrical range of 100 - 240v and 50 - 60hz.
2. The charger has two LED lights:
Left LED: Orange when charging NiMH batteries.
Right LED: Orange when fast charging.
Green during top-up charge and when charge is complete.
3. To attach charger to battery, align arrow on charger connector with arrow on battery
label and push together until connectors seat (Refer Fig. 25).
Note: The fast charger time is approximately 2.5 hours.
(Fig. 25) (Fig. 26)