Page 10
263920 R
2
I
nstallation
MA3188.eps
Upper Hose Guide
16
19
17
19
Outer
Upright
Outer
Intermediate
Upright
Inner
Intermediate
Upright
Inner
Upright
Crosshead
Components
Carriage
Components
Lower Inner
Components
Lower Guides
7
9
5
6
4
Figure 12.Installing internal hose reeving components on uprights.
6.
Install the lower hose guide to the outer intermedi-
ate upright. Tighten the capscrew to 30 ft-lbs (41
Nm).
7.
Install hose clamps to lower guide. Leave
capscrews finger tight.
8
. Completely lower the carriage. Route the short
hoses down behind the carriage bar to the carriage
bracket fittings. Connect the hose ends to the
fittings leaving the hose ends finger tight. 35DV
Double Function: The No. 4 hoses connect to the
two right fittings (viewed from the driver’s seat).
2.4-2
Internal Reeving
STANDARD
( Continued )
9.
Route the hoses over the crosshead sheaves.
10.
Route the hoses down between the freelift
cylinder and crossmember. Position the hoses in
their natural curve over the crosshead sheaves.
Tighten the hose ends at the carriage bracket.
11.
Connect the long hoses to the short hoses behind
the freelift cylinder. The outside hose(s) is
approximately 4” shorter than the inside hose(s).
See figure 13.
12.
Pull down on the hoses with approximately 30 lbs.
of force. Clamp the hoses to the lower bracket
attached to the inner upright crossmember.
Tighten the capscrews to a torque of 7-11 ft-lbs
(10-15 Nm).
