‐ ‐
11
3. Preparing and installation
3.1. Site Selection
The hydraulic motorcycle lift is designed only for indoor use. Application in a room with
explosion hazard is not permitted. Setting in a wet place, a car wash center for instance, is
forbidden.
3.2. Surface Condition
The lift should be installed on level ground with a concrete surface free from as many defects
as possible to prevent unit from tipping or rocking.
Failure in accomplish the foundation requirement may cause the lift instability or
personal injury. Installing on asphalt, soft clay floor or near the expansion gap is
prohibited.
3.3. Necessary Tools
Rubber Hammer, Sockets and Open End Wrenches. Ratchet Driver, Vice Grips
3.4. Personal Protective Equipment
Always wear proper protective Equipment like working suit, shoes, gloves & glasses, etc.
3.5. Installation Instruction
1.
Unpacking
Open the carton. Using a forklift to take out the bench then move to desired position (Fig. 4a,
4b) and the lift up the upper platform.
Fig.4a
Fig. 4b Fig. 5
2.
Assembling
a. Loosely attach the vice rails in the appropriate holes in the front deck of lift ( Fig.5).
