MP
BP
SC
Align the hole in the Middle Pole (MP) with the slot
in the Bottom Pole (BP) and slide the Middle Pole
over the Bottom Pole.
Do not jam the poles together until instructed.
Insert the remaining
1/4” x 3/4” Screw (SC)
through the small hole
in the Middle Pole and
into the Bottom Pole.
The Screw will spin
freely once installed.
Note: There are three screw holes at the bottom
of the pole. The correct hole will be slightly larger
and slightly higher up on the pole than the others.
SC
()
00775
Required For
This Page:
5
This step cannot be reversed.
BP
MP
TP
In order to seat the Poles, strike each end of the Pole very hard 5
to 6 times on a piece of scrap wood or cardboard. This must be
done even if the poles cover the slots before seating.
If the Top and Middle Poles do not completely cover the
slots on the Middle and Bottom Poles after seating, DO
NOT COMPLETE ASSEMBLY. Call our Customer Service
Department.
Do not hit your feet with the pole sections, as serious injury
could occur.
WARNING
The poles must be seated together!! Even if the poles cover the
slots before seating, you must strike them hard on the wood
five to six times!! Failure to seat the poles correctly could allow
the poles to separate during use, which could lead to serious
personal injuries or property damage as listed on Page Two.
