Lifetime FOOT ADJUST, Assembly Instructions Manual

Page: 7 / 44

7
TOOLS AND HARDWARE REQUIRED
• Strike the end of the Pole Assembly on a piece of scrap wood or cardboard 5–6 times.
1.5
X
SECTION 1 (CONTINUED)
6x
• Do not strike your feet with the Pole sections, as
serious injury may occur.
!
1.4
• Repeat step 1.4 for the opposite end of the Pole Assembly . Now that the Pole Assembly is seated, use a 10-foot Tape Measure to
measure the pole from top to bottom to the nearest eighth of an inch. Write this measurement down in inches; you will
need this later in the assembly.
1.5
6x
WARNING
The Poles must be seated together! Even if the Poles cover
the slots before seating, they must be struck on a hard
surface five to six times! Failure to seat the Poles correctly
could allow the Poles to separate during use, which could
lead to serious personal injuries or property damage.
Measure from here... ...to here.