Lifetime FOOT ADJUST, Assembly Instructions Manual

Page: 10 / 44

10
TOOLS AND HARDWARE REQUIRED
X
SECTION 2 (CONTINUED)
• Place the Pole assembly on the ground with the Pole Bracket on the Bottom Pole facing up. Position the Large Axle (AJC)
under the bottom slots of the Base (AJM) as shown, and step onto the Base so the Axle snaps into the slots. Then rotate the
Pole assembly upward so that the Small Axle (AJE) snaps into the upper slots of the Base as shown. Secure the hardware
shown using the Hex Wrenches provided.
2.3
3/16”
DSA (x1)
BTS (x1)
AJC
DSA
BTS
AJE
ALE
CCL (x2)
• Tip the system forward so the Pole rests on the ground. Do not stand the system up until it is fi lled with either sand or
water later in the assembly. Tighten the hardware shown.
2.4
1/2" (x2)