8
Required For This Page:
Pliers
RE
AP
AQ
RE
17.1
Hold the Backboard
Brackets (AP & AQ) together
and slide the U-Bolt (RE) through the
holes as shown.
17
18.1
Ensure the U-Bolt (RE)
is in the notches.
18.2 Completely tighten the Nuts
(MA).
18
19
19.1
Insert a 5/16” x 2”
Carriage Bolt (RC) through
each hole in the Rim Pivot Bracket
(RI).
MB
ML
MB
AP
AQ
MI
RE
MI
RC
RI
RC
AO
20.1
Use the 1/2” socket
head from the socket head
wrench to press one Push Nut (RB)
onto one end of the Axle (RH).
20
RB
RH
RC
RB
RI
(Not actual size)
MB
MI
ML
9/16” Wrenches
1039829
1003678
(2)
(2)
(2)
(1)
(2)
(2)
22
22.1
Lay the Backboard (AU) on a table or bench.
Note:
The U-Bolt (RE) goes
through the top holes in the
Backboard.
RE
AU
RB
RH
RI
AO
RH
21.1
Slide the end of the Axle (RH) through the Rim (AO) and the
Rim Pivot Bracket (RI). Press the Push Nut (RB) onto the end
of the Axle. Use the 1/2” socket head to secure the Push Nut if
needed.
Note: The Push Nut should rest about
1/4” from the end of the Axle. If the
Push Nut slips on too far, continue
sliding it to the other end of the Axle to
remove it and try again.
21
1/2” Socket Wrench
