9
Console Assembly
1. Hold console on the console tube as shown in Figure 5.
2. Connect ground wires E1 E2 . ( FIG-6 )
3. Connect wire harness F1 F2 . ( FIG-6 )
4. Connect hand pulse cables G1 G2 . ( FIG-6 )
Note: Insert excess wire harness into right side of console tube.
6. Connect the Speed Control Harness M1 M2 . ( FIG-6 )
7. Connect Incline Control Harness P1 P2 . ( FIG-6 )
5. Fix console on the bracket by tightening 4 screws Q .
Warning: Make sure all the cables/wires are not pinched when the console screws are tightened.
Cup Holder Assembly
1. Attach the right cup holder to the console tube and the right handlebar. Rotate the
console tube if necessary to make sure the cup holder fits snugly on the handle bar.
2. Attach screw T from the top of the cup holder onto the handlebar and tighten.
3. Attach screw Q from the bottom of the cup holder to the console.
4. Repeat the above steps to fix left cup holder on handle bar. ( FIG-7 )
Complete Assembly
Make sure the console and the cup holders
are aligned and then tighten the 4 screws S
under both sides of console tube. ( FIG-8 )
