14
5. KEY FUNCTIONS
SET KEY
a. Press once to increase once, long press for rapid increase setting.
b. B. TIME range: 0:00~99:00(INTERVAL: Every time the adjustment rises 0:01, TIME: Every time
the adjustment rises 1:00).
c. CAL range: 0~9990(every time the adjustment rises 10).
d. DIST range: 0~9990(every time the adjustment rises 10).
e. STROKES range: 0~9990(every time the adjustment rises 10).
f. PULSE range: 30~230 (the default is 100
，
every time the adjustment rises 1:00).
g. Press MODE KEY for 2 seconds in IDLE mode to switch between metric and imperial.
MODE KEY
a. In manual mode, press once to confirm.
b. In setting mode, press once to confirm.
c. In running mode, press once to pause.
d. Each press with beep sound.
e. Press SETKEY for 2 seconds in IDLE mode to switch between metric and imperial.
RESET KEY
a. In function setting mode, press once back to preceding function.
b. In setting mode, press once to eliminate current setting value.
c. In pause mode, press once back to IDLE mode.
d. Each press with beep sound.
e. Press 3 seconds to TOTAL RESET, and console will eliminate current workout value except
TOTAL STROKES.
※
TOTAL STROKES value will cancel automatically when the power off.
6. FORMULAS & PARAMETERS
1.
SPM: pulling frequency per minute (time of one pulling).
2.
TIME/500 (min: sec) = 500M/(SPM*DIST) unit is minute.
3.
WATT, CALORIES, DISTANCE calculations as CONCEPT II.
4.
Induction method as below:
a. Double SENSOR mode: Two RPM input: power on, the sensor which first receive RPM is A
and the other is B. Induction calculation way: ABBA is one time.
b. Signal SENSOR mode: Use the magnetic speed to judge the induction times. Method of
SENSOR induction: slow-quick-slow is one time.
7. ADDING WATER & REMOVING WATER
Adding water:
1. Take off the plug of water tank’s left side.
2. Place a water bucket next to the rowing machine, then put the hard tube of siphon into the bucket and the
hose into the water tank. Please close the valve on the top of the siphon when pouring water into the tank.
3. Press the siphon to pour 17L water into the tank (DO NOT exceed the water line).
4. When pouring to the proper level, please open the valve on the top of the siphon to let extra water flow out.
5. Please make sure the plug is closed after pouring water.
6. Siphon using technique: place the bucket higher than water tank then the water automatically flows into
water tank. (Place a cloth under the water tank when pouring water in case wet the floor.)
Removing water:
1. Take off the plug of water tank’s left side.
2. Put the hard tube of siphon into the water tank and the hose into bucket.
