LIFESPAN PERFORMER PLUS
23
minutes of use, the belt should have a tendency to centre itself. If during use, the belt
continues to move toward one side, adjustments are necessary. The procedures are as below:
▲
First set speed at lowest position.
▲
Second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using 6mm
Hexagonal Wrench, until the belt is centered itself; If belt shifts to left, tighten the left bolt and
loosen the right bolt by using 6mm Hexagonal Wrench, until the belt is centered. When
adjusting the belt using the 6 mm Hexagonal Wrenches, it is important to adjust the belt in
half turn increments. Over adjusting the belt can cause damage to the mat.
6. TROUBLE SHOOTING
This treadmill is designed in a way that in the event of an electrical fault, the machine will turn
off automatically to prevent any injuries to the user and to prevent damage to the machine (i.e.
motor).
When the treadmill behaves erratically, simply reset the treadmill by turning the power switch
off, waiting for 1 minute then turning the power button back on.
If, after you have reset the treadmill, it is still not running correctly, please run the self-
checking analyse (please refer to 4.3 Self-Checking) to distinguish what type of error
problem the machine is encountering.
6.1 Alarm signals
E1: No feedback from controller or speed sensor
1.
Check the condition of cables and ensure that all plugs are connected between the motor
controller and display.
2.
Check that the speed sensor and magnet are in correct alignment and that there are no
obstructions on the magnet. (The magnet can be found on the front roller near the motor
Before attempting any work on the treadmill, ensure that the power is off and the
plug is removed from the power point.
Do not use extension leads as it may lead to power decrease and failure.
