10
Rhythm User Manual Lifepro
Re Fitness Collection
11
DONE
Figure 7
Figure 6
Figure 5
Figure 4
Figure 8
Figure 9
Figure 10
STEP 2: ATTACH SUPPORT TUBES
You Will Need
• Handrail Support Tubes (2)
• Hex Wrench #5
• M6x10 Socket Screws (4)
1. Attach a handrail support tube to each side of the
base.
NOTE:
The handrail support tubes angle away from
the support column (the screw holes at the top of
each support tube will point toward the support
column). See
Figure 4
.
2. Use two of the M6x10 socket screws to secure
the bottom of each support tube to the base.
Loosely tighten all four screws using the included
#5 hex wrench. See
Figure 5
.
STEP 3: ATTACH HANDRAILS
You Will Need
• Handrails (2)
• Hex Wrench #5
• M6x10 Socket Screws (4)
• M6 Flat Washers (4)
1. Fit a handrail onto the top end of each handrail
support tube.
NOTE:
When fitted correctly, both handrails will
curve in toward the support column. A white electrical
wire extends from the end of each handrail which will
attach to the support column. See
Figure 6
.
2. Use two of the included M6x10 socket screws and
two of the M6 washers to attach each handrail to
a support tube. Loosely tighten the four screws
using the #5 hex wrench. See
Figure 7
.
STEP 4: SECURE HANDRAILS
You Will Need
• M8x50 Socket Screws (2)
• Hex Wrench #5
1. Use the two long M8x50 screws and hex wrench
to loosely attach each handrail to the top of the
support column. See
Figure 8
.
NOTE:
Thread the white wire in each handrail through
the opening between the two handrails. See
Figure 8
.
STEP 5: CONNECT WIRES
You Will Need
• Console
1. Connect the black wire from the back of the
console to the black wire at the top of the support
column. See
Figure 9
.
2. Connect the two white wires from the back of the
console with the white wire from each handrail.
See
Figure 9
.
STEP 6: ATTACH CONSOLE
You Will Need
• Hex Wrench #5
• M6x10 Socket Screws (3)
• M6 Flat Washers (3)
1. Feed the wires into the opening at the top of the
support column and place the console flat against
top of the column.
2. Loosely attach the console to the column using
the three remaining M6x10 screws and the three
remaining M6 washers. See
Figure 10
.
2
3
4
6
5
