14
7. Handlebar and Computer Installation
Remove two Ø16xØ8x1.5t Curve Washers (24) and two M8x20mm Bolts (89) from the Front
Post (32). Remove bolts and curve washers with an Allen Wrench provided. Connect the
Sensor Wire II (36) from the Front Post (32) to the Sensor Wire II (36) from the Handlebar
(23). Then attach the Handlebar (23) onto the Front Post (32) with two Ø16xØ8x1.5t Curve
Washers (24) and two M8x20mm Bolts (89) that were removed. Tighten bolts and curve
washers with an Allen Wrench provided.
Connect the Sensor Wire II (36) and Hand Pulse Sensor Wires (21) from the Handlebar (23)
to the wires that come from the Computer (18) and then attach the Computer (18) onto the
top end of the Handlebar (23) with two ST4.2x20mm Screws (9). Tighten screws with a
Multi Hex Tool with Phillips Screwdriver provided.
Hardware:
Allen Wrench S6
Tool:
Multi Hex Tool with Phillips Screwdriver
S10, S13, S14, S15
24
24
89
89
23
23
36
36
32
32
18
18
21
21
36
36
21
21
36
36
9
(9) Screw ST4.2x20mm
2 PCS
