9
2. Front Post and Tension Control Knob Installation
Remove six M8x16 Bolts (41), six Ø8 Spring Washers (60), and six Ø20xØ8 Curve Washers
(42) from the Main Frame (1). Remove bolts and washers with the S6 Allen Wrench
provided.
Insert the Tension Cable (30) through into the bottom hole of Front Post (5) and pull it out
from the square hole of Front Post (5).
Connect the Sensor Wire II (68) from the Main Frame (1) to the Sensor Wire I (67) from the
Front Post (5).
Insert the Front Post (5) onto the tube of the Main Frame (1) and secure with six M8x16
Bolts (41), six Ø8 Spring Washers (60), and six Ø20xØ8 Curve Washers (42) that were
removed. Tighten bolts and washers with the S6 Allen Wrench provided.
Remove the Ø20xØ5.2 Curve Washer for Tension Control Knob (64) and M5x25 Bolt for
Tension Control Knob (65) from the Tension Control Knob (54). Remove bolt and curve
washer with the Multi Hex Tool with Phillips Screwdriver provided.
Put the cable end of resistance cable of Tension Control Knob (54) into the spring hook of
Tension Cable (30) as shown in drawing A of figure 2. Pull the resistance cable of Tension
Control Knob (54) up and force it into the gap of metal bracket of Tension Cable (30) as
shown in drawing B of figure 2. Attach the Tension Control Knob (54) onto the Front Post
(5) with the Ø20xØ5.2 Curve Washer for Tension Control Knob (64) and M5x25 Bolt for
Tension Control Knob (65) that were removed. Tighten bolt curve washer with the Multi
Hex Tool with Phillips Screwdriver provided.
1
5
30
60
60
64
65
68
67
41
42
41
54
30
54
54
30
30
B
A
Allen Wrench S6
Multi Hex Tool with Phillips Screwdriver
S10, S13, S14, S15
Tool:
