LifeFitness 9500HR, Service Manual

Page: 33 / 75

5
Lifecycle 9500HR Series Exercise Bikes
DIAGNOSTIC MODES (Continued)
DIAGNOSTICS STATE 3 - VERSION #: RPM, HR, and LOAD TESTS
The PROGRAM VERSION NUMBER (ex. P2.41) will be displayed in the ELAPSED TIME window.
The present RPM will be displayed in the RPM window.
The HEART RATE, if present, will be displayed in the LEVEL/HEART RATE window.
The present LOAD DUTY CYCLE applied to the alternator will be displayed in the CALORIES/HOUR window.
LOAD duty cycle ranges from 0-250 in order of increasing load. This value can be adjusted using the ‘1’ and ‘3 or
the UP/DOWN keys to change load resistance in increments of one. The ‘4’ and ‘6’ keys can be used to increase
and decrease the LOAD duty cycle by 10’s.
With hands on all four LIFEPULSE sensors an “HR” will display in the LEVEL/HEARTRATE window, followed by
the actual HEART RATE.
Pressing the ‘CLEAR/PAUSE’ key will return to DIAGNOSTICS STATE 2.
Pressing the ‘START/ENTER’ key will advance to DIAGNOSTICS STATE 4.
DIAGNOSTICS STATE 4 - LIFEPULSE and NETWORK STATUS TESTS
The PROGRAM VERSION NUMBER of the HEART RATE DSP board ‘05 software (ex. P1.80) will be displayed in
the ELAPSED TIME window.
The PROGRAM VERSION NUMBER of the HEART RATE DSP board DSP software (ex. P3.90) will be displayed
in the SPEED window.
The status of the LIFELINK board and LIFE CENTER connection will be displayed in the CALORIES/HOUR
window. The following conditions will be reported.
‘NONE’ - No LIFELINK board detected.
‘NULL’ - Board detected but not communicating.
‘.ON ‘ - ONLINE status with LIFE CENTER
‘OFF ‘ - OFFLINE status with LIFE CENTER.
Pressing the ‘CLEAR/PAUSE’ key will return to DIAGNOSTICS STATE 3.
Pressing the ‘START/ENTER’ key will advance to DIAGNOSTICS STATE 5.
DIAGNOSTICS STATE 5 - LOOPBACK TEST
Within this state, the RS232 port is tested. A shorting jumper must be connected for the result of this test to be
correct.
If functioning correctly, “RS232 PASS” will be displayed.
If not-functioning correctly , “RS232 OFF” will be displayed.
Pressing the ‘CLEAR/PAUSE’ key will return to DIAGNOSTICS STATE 4.