Composition and layout
Composition:
First turn off the machine and unplug the power cord. Unscrew the fixing screw, then
lift the belt and fold the machine. Remove the locking screw, adjust the position and
fix the machine in the vertical position. Now you can move the machine using the
wheels.
Layout:
Take out the safety screw and put down the machine slowly. Tighten the mounting
screw and connect the machine.
6.
Checking V-belt and treadmill settings
If you seem to slip the treadmill, the next steps will determine which part is a release
and needs to tighten, if it's a running belt or a V-belt on the engine.
1.
Turn off the main switch off and unplug the power cord (out of the socket).
Loosen the side bolts on the engine guard and take down the cover.
2.
Turn on the treadmill again and set the speed to approximately 3km / h. Stand
on the belt and pull it firmly (pressure) to stop it.
3.
If the belt is paused along with the front roller, it means that is neccessary has to
be tensioned the V-belt.
4.
If the treadmill (area) is stopped but the front roller is still spinning it means
After completing this check and setting, screw the engine protection cover.
8.
Adjustment of the treadmill and adjustment the treadmill
deviation
Turn the two screws at the ends of the belt in the same direction by half a turn. If the
belt area still slips, repeat the previous step. At this adjustment, you can start the
belt at a speed of approximately 5-6 km / h.
a)
Belt tension - screw in clockwise direction.
We allow against the
clock.
