Page | 4
12. Perform proper maintenance as recommended in this manual.
13. Save this manual for future reference.
Assembly Instructions
Assembly Tips
The LifeCORECD550 is made from the best materials and has been tested and received a quality
control review prior to its packaging to ensure the correct parts and proper fitting of each component.
This machine was designed to limit the amount of assembly needed by a consumer.
Before assembly of your product, distinguish a proper and appropriate location for the unit where
there is easy access to an electrical outlet with a surge protector. Unpack the box in a clear work
area to allow smooth assembly. Remove all of the parts from the packing material; however, do not
discard packing material until assembly is complete. Double check packing materials to ensure no
missing parts were left behind.
Note that some hardware may be preassembled to components in order to help with assembly; tools
have also been provided to assist with assembly.
Figure 3
Figure 5
Apply Grease
Assembly Assistance
In each CD550 assembly pack, there
is a tube of grease for assembly
purposes. A small even amount of
grease must be applied to the pivot
points during assembly. Apply about
two finger tips worth of multi-purpose
grease onto the bottom of both foot
pedal tubes in the area that makes
contact with the roller wheel. (Parts
#2CU8 Shaft Wheel w/ball bearing)
Figure 3 – Green Arrows
During Step 3 assembly, apply about
a finger tips worth of assembly grease
on each pivot point, shaft and
bearings prior to connecting arms.
Figure 5 – Green Arrows
During Step 5 assembly, apply a
small even amount of grease to the
pedal tube and handrail assembly
tube pivot point
on each side. In
addition, evenly apply grease to the
M10 * 81.5 Hex Bolt before joining the
two assemblies.
NOTE: DO NOT USE WD-40 OR
SILICONE
SPRAY-This
will
increase squeaking noise.
