PHASE 2
1
3
2
5
4
OK
Switch on power to the system and check that the two
red LEDs flash.
PROGRAMMING THE TRAVEL
a) Press
for 5 seconds, the 5 LEDs will light and
then start flashing.
b) Press
: the automation will perform, in sequence,
a closure
(1)
, an opening
(2)
, a closure
(3)
, a opening
(4)
and another closure
(5)
.
Once programming is complete, the two green LEDs will
flash and the red led
(DX)
will light.
Should the result obtained not be satisfactory, repeat the
whole process.
PHASE 3
P
RADIO CONTROL INITIALISATION ON THE STEP
COMMAND (P)
a) Press
, the green led
(SX)
will light.
b) Hold down the key
(P)
on the radio control until all five
LEDs light
.
c) Wait 25 seconds or press
again to quit.
The automation is now programmed.
SEMIAUTOMATIC mode is enabled: by giving the ‘
STEP
’ command, the automation changes movement following the sequence 1 –
OPEN
2 –
STOP
3 –
CLOSE 4 – STOP. Automatic re-closure is not enabled.
Once programming is complete, the
key acts as a STEP command.
PHASE 1
PR70 – 80: PROGRAMMING THE CONTROL UNIT
DEFINING THE STOP PLATES
Ensure that the automation’s opening and closure stop
plates have been fixed.
ON
230V
ON
Energy Saving
In order to save energy, we have introduced the function
Energy Saving. 10 minutes after the end of programmation of the control board, the LED
of the keyboard go out and it is no more possible to use the control board. To get the control
board working again, switch it off and on.