Life Span ZOOM, User Manual

Page: 24 / 33

LIFESPAN ZOOM Page 23
• Turn off the treadmill with the on/off switch, then unplug the power cord and wait 60
seconds.
• Remov e the motor cover. Wait unt il ALL LED lights turn off.
• Clean the motor and lower board area to eliminate any lint or dust particles that may
have accumulated.
Failure to do so may result in premature failure of key electrical components.
EVERY 6 MONTHS
It may be necessary to lubricate your treadmill running deck at least once every six
months to maintain optimal performance of your treadmill (refer to section 4.4 for
information). Only use lubricant provided by Lifespan Fitness! Please contact Lifespan
Fitness with questions about applying lubricant to your treadmill.
• Turn off the treadmill with the on/off switch, then unplug the power cord at the wall
outlet.
• Loosen both the rear roller bolts. (For best results, place two remo vable marks on
both sides of the frame and note roller position).Once the belt is loosened, take the
bottle of lubricant and apply it to the entire top surface of the running deck. Tighten
both rear roller bolts (matching up the marks for proper position) to original position.
After you have applied lubricant, plug in the power cord, key, start the treadmill and
walk on the belt for two minutes to spread the lubricant.
• Lubricate the air shocks with Teflon based spray.
SERVICING: IF YOU FAIL TO COMPLY WITH LIFESPAN’S MAINTENANCE AND SERVICING
STEPs ABOVE, YOU MAY VOID YOUR WARRANTY. IF YOU REQUIRE A SKILLED LIFESPAN
REPRESENTATIVE TO UNDERTAKE ONe OF THE STEPS ABOVE, PLEASE VISIT LIFESPAN’S
website www.lifespanfitness.com.au.
4.2 General Cleaning

Use a soft, damp cloth to wipe the edge of the belt and the area between the belt
edge and frame. A mild soap and water solution along with a nylon scrub brush will
clean the top of the textured belt. This task should be done once a month. Allow to
dry before using.
EVERY 2 YEARS
It is necessary that you change your treadmill motor brushes once every 2 years to avoid damaging your
motor. If you fail to change the brushes this may cause the motor to burn out, voiding any warranty.
PLEASE NOTE: TREADMILL MOTOR BRUSHES NEED TO BE CHANGED EVERY 2 YEARS
OTHERWISE MOTOR WARRANTY WILL BE VOID.REFER TO MANUAL