8
Control Panel
Remote Control
FIREPLACE OPERATION
Plug your Infrared fireplace heater power cord into a 120V, 15amp or 20amp three-bladed receptacle.
To Turn the Fireplace On
: Press the Power button
on the control panel or on the remote
control.
Default Set Temperature
: The default set
temperature every time the heater is powered on is
typically 72°, this cannot be changed.
Ambient Temperature:
To view the ambient room
temperature, press and hold the Temp up
button
for a few seconds, the room temperature will display
for a short period of time, then return to the desired
set temperature.
To Set Desired Temperature:
Press the UP
or DOWN
button on the control
panel or on the remote control. When the desired set
temperature is reached by the heater’s internal
thermostat, the heater will stop heating automatically,
but the fan will continue to run for approximately 5
minutes (3 minutes when powered off) so that unit’s
chamber can cool. When the ambient temperature
drops below the set desired temperature, the heater
will cycle on again.
To Set Heat Level:
Press the H/L button
on the
control panel or remote control to switch between High
and Low heat. The corresponding High (H) or Low (L) light will switch on. In the High mode, the
fan will not change speeds. Rather, the heating elements will allow for higher heat output. The
High level uses 1500 watts, while Low heat level uses approximately 1000 watts.
Celsius and Fahrenheit:
The heater displays temperature in Fahrenheit as the default, but has
the capability to display it in Celsius as well.
To change between °Celsius and °Fahrenheit:
Press
To Set Flame Brightness
: Use the Dimmer button
on the control panel or remote control.
The flame brightness control button is used to increase or decrease the brightness of the flame
and ember
. Flame effect can work independently of fireplace heater. When Pressing the
dimmer button repeatedly, the brightness of the flame will cycle ON-HIGH-MEDIUM-OFF.
