14
USER’S GUIDE
Plug your Infrared Heater power cord into a 120V, 15amp (or higher) three-prong receptacle.
To Turn the Heater On:
1. Turn the Master toggle switch in the back of the heater
to the “On/Lit” position.
2. Press the
“
Power
” button on the front control panel or the remote control.
Heater Default Temperature:
The heater’s default temperature every time it is powered “on” is 72°F.
Note that the heater will not activate its heat elements or fan, if the starting ambient
temperature (temperature in the room) is above 72°F.
If this is the case, the set desired temperature must be first be adjusted above the
ambient temperature.
Ambient Temperature (room temperature)
:
To view the ambient room temperature, press
the
“
Temp up
” and “
Temp down
” buttons at the same time for appx 3 seconds. The room
temperature will display for 5 seconds then return to the desired set temperature.
Set Desired Temperature (Goal Temperature)
:
Press the
“
Temp up
” or “
Temp down
”
button on the control panel or on the remote control to select the Set Desired Temperature. The
heating process will begin.
When the heater detects that the ambient room temperature matches the set desired
temperature, the heating will stop automatically.
The fan will continue to run for a few extra minutes so that the
unit’s chamber can cool,
then the fan will also shut off. When the ambient temperature drops below the set desired
temperature once again, the heater will restart the heating cycle.
To Set Heat Mode:
Press the
“
Heating
” button on the control panel or “
Heat
” button on the
remote control to switch between the High, Low, and Eco modes. The corresponding word
"High", "Low" or "Eco" will display on the panel. Note that in all modes, the fan speed will remain
the same.
