Life Ionizers Fuzion, User Manual

Page: 13 / 24

www.LifeIonizers.com
13
75 F U Z I O N
Problem and Solution Chart
Problem Reason Solution
My alkaline water is white. It’s oxygen and hydrogen gas. Drink it! It’s great for you!
I press the Start button and no
water is released. • May not be plugged in.
• There may not be any
water in the Source
Water Tank.
• One of the tanks my not
be fully pushed into the
LIFE Fuzion™
• Check the plug.
• Check the tanks.
• Put water into the LIFE
Fuzion™ Source Water
Tank.
I’m pressing the pH Select
button and the levels aren’t
changing. Holding the button down
continuously. Release the button and then
press it again.
The red lamp is flashing. Either the acid water tank is
full or it is not pushed all the
way into the LIFE Fuzion™. Empty the acid tank. Push the
tank all the way into the LIFE
Fuzion™.
The blue lamp is flashing. This indicates the cleaning
cycle needs to run. Fill the Source Water Tank and
press the Start button. This
wil initiate the cleaning cycle.
When the cycle is complete,
the blue lamp will stop flash-
ing and you can use your LIFE
Fuzion™.
No lamps are on or flashing
even though the LIFE Fuzion™
is plugged in. The LIFE Fuzion™ has gone
into standby mode because
it hasn’t been used for one
minute. Press the Start button and it
will turn on again.