21
button until you see a "
◆
" icon flashes on the left upper corner of the CALORIES window.
Press the SET button to pre-set values of target CALORIES. Press the RESET button to
reset the target calories to zero. Once you pre-set target calories and then start to exercise,
calories start counting down from pre-set target calories to 0.0. When the pre-set target
calories count down to 0.0, the computer will begin beeping to remind you. (This data is a
rough guide for comparison of different exercise sessions and should not be used in medical
treatment).
PULSE:
Before measuring your current heart rate figures, press any button, "P" will change
into "0" on PULSE window. Then the PULSE window will display your current heart rate
figures after you grip the handlebar sensors with both your hands during exercise. To
ensure the pulse readout is more precise, please always hold on to the handlebar grip
sensors with two hands instead of just with one hand only when you try to test your heart
rate figures. You may also pre-set target heart rate in STOP mode before training. To set
CALORIES press the MODE button until you see a "
◆
" icon flashes on the left upper corner
of the PULSE window. Press the SET button to pre-set target heart rate. Press the
RESET button to reset the target heart rate to zero. Once you pre-set target heart rate and
then start to exercise, please grip the handlebar sensors with both your hands during
exercise. If the heart rate detected greater than the target heart rate, the computer will
begin beep to remind you.
HOW TO INSTALL THE BATTERIES:
1. Remove the battery cover on the back of the computer.
2. Place two size AA batteries into the battery housing.
3. Insure batteries are correctly positioned and battery springs are in proper contact with
batteries.
4. Re-install the battery cover.
5. If the display is illegible or only partial segment appears, remove the batteries and wait
15 seconds before reinstalling.
Summary of Contents for Orbi trac 28320
Page 9: ...8 OVERVIEW DRAWING ...
